Dehumidifiers, Air Chambers, Battery Conditioners and much more!

The serious collectors choice for long term vehicle preservation. Easy to erect, economical to run and simple to use - just drive in, zip up and switch on. Twin fans force up to 50,000 litres of clean, filtered air across every surface of your vehicle evaporating moisture and banishing condensation. Compared to collapsible, zip-up bag type systems, which waste hours in re-inflation and drag on your car, this is simple, quick and sturdy. You can even open car doors to access them inside seconds.

The Mitsubishi MJ-E16VX-E1, a superbly built refrigerant (compressor) dehumidifier, is mechanically the same as the MJ-E16V-E1 but has extra adjustability and a in-built LCD display. This shows the real time humidity level in the room as well as allowing the adjustment of the humidity cut-off point and settings for the powered louvre and timer functions. This model also has a powered louvre, child lock and washable photo-catalytic anti-bacterial filter. Recommended for car storage (large double or triple garage) or 5 bedroom house.

The Mitsubishi MJ series machines are simply the best built, quietest, most reliable and most efficient refrigerant dehumidifiers available for home and garage use. Noise levels are minimal and reliability is superb. They are ideal for garage use because they can be left unattended for long periods. Automatic controls regulate the air moisture to your set levels Auto cut-off when condensate tank is full - or condensate can be plumbed to drain away Hot gas defrost means they work right down to sub-zero temperatures

The CTEK MULTI XS 25000 is powerful for batteries that require rapid charging: in your RV, boat, or workshop. The charger automatically adjusts the charge to the battery's temperature. The CTEK MULTI XS 25000 has the same handy Supply-Mode as the CTEK MULTI XS 7000. The CTEK MULTI XS 25000 features built-in functions that analyse the status of your battery. Maintenance charging uniquely combines battery requirements of high capacity and long life. The CTEK MULTI XS 25000 is delivered with a battery lead with clamps, colour coded for easy +/- identification. The charger also has a sensor cable located together with the battery leads. The unit automatically adjusts the charge voltage if the temperature deviates from +25°C. Higher temperatures lower the voltage and lower temperatures raise the voltage. The sensor cable can be extended or shortened without affecting functionality. The charger must be fitted with the top or long side facing up to be approved for outdoor use. Lead Lengths From mains plug to unit = 1.7m From unit to connectors = 1.5m

The Meaco DD8L dehumidifier has everything you need for a stylish, quiet, high performance dehumidifier packed with the latest technology. DD8L is perfect for use in cold temperature unheated winter environments like garages, workshops, boats and caravans. Auto restart after power interruption means you can put it on a timer if you want or leave it unattended long term. Continuous drain option using the hose supplied as standard with the machine makes it a great 'plug in and forget' machine.

The Meaco DD8L Junior dehumidifier has everything you need for a stylish, quiet, high performance dehumidifier packed with the latest technology. DD8L Junior is perfect for use in cold temperature unheated winter environments like garages, workshops, boats and caravans. Auto restart after power interruption means you can put it on a timer if you want or leave it unattended long term. Continuous drain option using the hose supplied as standard with the machine makes it a great 'plug in and forget' machine. it is visually identical to the Meaco DD8L machine but without the ioniser and silver nano filter which are not required in garages. It therefore offers a worthwhile saving of £30.

The new OptiMate 4 is new in nearly every way, apart from its well-proven diagnostic and recovery capabilities, which are now even further enhanced. The connectors of the charger output lead as well as the eyelet and clamp leads all feature integral “glide-guides”. These serve 2 purposes – to help weatherproof the cable entries and to hold the connector pins in exactly the right place. This means that there is now no possibility of the pins to becoming mis-aligned, something which was possible in the past and is still the case with competitors’ connectors. Electronic improvements are wide-ranging. Inside the new housing is a completely new electronic circuit board. The new OptiMate 4 is much more efficient than the OptiMate IIISP which it replaces. It delivers 33% more charging power but consumes less electricity, which also means less heat is generated as a result. The enhanced electronic functions are now controlled by a microprocessor, which allows additional stages and monitoring controls as well as an expanded and more precise end-of-programme test for power drain. An improved control panel explains the test results and general operation to the user much more intuitively than previously.

The AccuMate is the sister product to the well established OptiMate battery charger/optimiser, which has a proven reputation with over 30,000 OptiMates sold annually in the UK alone. Like the OptiMate, the AccuMate is designed to automatically charge and monitor batteries with no danger of over-charging regardless of time. The AccuMate is suitable for all 6 and 12V lead acid batteries from 4Ah to 75Ah, making it perfect for owners of older vehicles which are not used on a daily basis. Operation of the AccuMate is completely automatic. It uses a 1.2A constant current charge as the main stage, while monitoring the battery voltage. When this reaches a pre-set cut off point, it then switches to an intermediate constant voltage 'float charge'. Only when the AccuMate has detected that the battery is properly charged, will it switch to the final stage for correct long-term battery maintenance, and indicate a green LED. If at any time the AccuMate detects that the battery has discharged, it will automatically revert to the constant current stage. Lead Lengths From mains plug to unit = 2m From unit to connectors = 2.4m Power usage on maintainance charge:

A brilliant idea - self adhasive thick pad to stick to your garage wall to prevent dents and chips to your car doors when opening. Also great to have at the end of the garage so you don't drive into the wall. These are much neater than old carpet, pipe lagging and stick permanently. Many architects and collectors specify them and buy a dozen or more at a time. A neat solution, proven over several years. Buy one now before you regret it ! Pricing update: These have always cost us more than our standard £3 postal rate to ship, currently £5.30 for one, £8 for 2. New Royal Mail postal changes from 2 April 2013 mean we can no longer use parcel post and they have to go by courier, at a cost of £6.65 plus vat. Very reluctantly we therefore have to increase prices from 2 April 2013 by £5 per single Pad to £23.99, but will offer a pair of pads at £42 (£21 each). This is net of our standard £3 carraige rate. We're sorry to have to do this but can no longer sustain the level of subsidy the new rates will necessitate. This good news is that all orders received by 2pm will benefit from tracked Next Day delivery and orders of 3 or more pads will cost no more to ship.

The CTEK XC 800 is a full-featured 6V charger in mini format. It gives the batteries of your vintage vehicle a new life. CTEK XC 800 charges small batteries that hold as little as 1 Ah, up to the biggest tractor batteries. The CTEK XC 800 is delivered with two different battery leads, one with clamps and one with eyelet terminals, all colour coded for easy +/- identification. If the battery is difficult to access, the lead with eyelet terminals can be mounted to the battery, and the quick connectors are located so that it is easily reached for charging. You can also purchase additional leads allowing you to have one lead with eyelet terminals fixed to all your vehicles with batteries that are difficult to get at, and charge them simply from the same charger. Lead Lengths From mains plug to unit = 1.7m From unit to connectors = 1.5m

A brilliant idea - self adhasive thick pad to stick to your garage wall to prevent dents and chips to your car doors when opening. Also great to have at the end of the garage so you don't drive into the wall. These are much neater than old carpet, pipe lagging and stick permanently. Many architects and collectors specify them and buy a dozen or more at a time. A neat solution, proven over several years. Buy one now before you regret it ! Pricing update: These have always cost us more than our standard £3 postal rate to ship, currently £5.30 for one, £8 for 2. New Royal Mail postal changes from 2 April 2013 mean we can no longer use parcel post and they have to go by courier, at a cost of £6.65 plus vat. Very reluctantly we therefore have to increase prices from 2 April 2013 by £5 per single Pad to £23.99, but will offer a pair of pads at £42 (£21 each). This is net of our standard £3 carraige rate. We're sorry to have to do this but can no longer sustain the level of subsidy the new rates will necessitate.

Gap Stop universal, flexible garage door seals are specifically designed to prevent draughts around your garage doors. They are an easy DIY fix. They are advisable when using a dehumidifier to reduce its workload if you have draughty doors and to prevent leaves and dust blowing in. They will also help keep your car free from spiders and dust!